Flyingsaw, Commissioning the "(flying saw) – Lenze EVS93xx FlyingSaw User Manual
Page 60
FlyingSaw
Commissioning the "(Flying Saw)"
Prepared Solution Servo PLC / ECSxA 1.1 EN
page 4-47
4.3
Commissioning of the Prepared Solution (parameterisable variant)
4.3.1
Download of the program FlyingSaw_SPLC_Vxxxxxx /
FlyingSaw_ECS_Vxxxxxx
Requirements:
The servo controller is configured and wired as per the wiring diagram in chapter 4.3.1 and the
product documentation.
The axis is inhibited using terminal 28.
The axis is supplied with the control voltage using the terminals 59 (+24V DC) and 39 (0V).
Understanding of code parameter setting using the keypad XT EMZ9371BC
The Prepared Solution and the necessary Lenze software tools are installed on your PC/laptop as
per chapter 4.2.
The system bus adapter EMF2177IB / EMF2173IB has been successfully installed.
By means of the XT EMZ9371IB keypad or GDC, set the following codes on the servo controller of the flying
saw axis in the order given:
C2108/000 2 = Stop the PLC currently running
C0002/000 0 = Set default setting
C0350/000 Node address for the servo axis (each node address is only allowed to be assigned once on
the system bus)
C0352/000
C0003/000
1 = Servo controller for the flying saw is bus master on the system bus
1 = Save system bus settings safe against mains failure
Fully isolate the flying saw servo controller and wait until the red and green status LEDs on the servo
controller go out, however at least 20s.
Step 2
Start
Step 1
Status LEDs
AIF slot