Lenze EVS93xx FlyingSaw - Manual (Page 71)

FlyingSaw
Commissioning the "(Flying Saw)"
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 4-58
Parameterise the profiles for the return travel of the flying saw and for the approach of the basic position next :
Set the following codes for setting the parameters:
Parameters for the movement to the initial position:
C3200/000
= Position entry for the movement to the initial position in [units]
C3201/000 = Velocity for the movement to the initial position in [units/s]
C3202/000 = Acceleration for the movement to the initial position in [units/s^2]
C3203/000 = Deceleration for the movement to the initial position in [units/s^2]
Parameters for the return movement profile after sawing
C3300/000
= Velocity in [units/s]
C3301/000 = Acceleration in [units/s^2]
C3302/000 = Deceleration in [units/s^2]
C3303/000 = Jerk time in [s]
Step 9
Step 8