Lenze EVS93xx FlyingSaw - Manual (Page 83)

FlyingSaw
Commissioning mark-controlled operation
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 6-2
Now set the specific parameters of your flying saw application.
You can describe your application for length-controlled operation using the following parameters:
C3007/000 In this parameter enter the set length. If a mark is not detected within the set length, the
material is processed as per the set length set here. This parameter is entered in the unit
[unit].
C3015/000 Distance between a touch-probe detection and the initial position of the tool. The entry is made
in the unit [units].
C3017/000 Activation of the length monitoring during mark control. The monitoring can be activated or
deactivated using this parameter.
Now check in the application status word whether the bits for the starting conditions are set correctly.
The following bits must be set for starting the length-controlled operation:
Bit 00 Program initialisation complete.
Bit 01: The axis home position is known.
Bit 04: The axis is in the "Standby" state.
Bit 14: The normalisation factor has been calculated.
Bit 18: The axis is in the initial position.
Step 2
Step 3