Flyingsaw – Lenze EVS93xx FlyingSaw User Manual
Page 73
FlyingSaw
Commissioning the "(Flying Saw)"
Prepared Solution Servo PLC / ECSxA 1.1 EN
page 4-60
4.3.3
Sequence for the online commissioning of the functions
Attention!
The commissioning of the Prepared Solution described in the following relates to the
parameterisable variant.
Requirements:
The parameters for the servo controller for the flying saw axis have been set to suit the specific
case, as described in chapter 4.4.3.
The axis is inhibited using terminal 28.
The axis is supplied with control voltage using terminals 59 (+24V DC) and 39 (0V) and with power
using terminals L1, L2 and L3.
Start GDC and perform a search for the drive controller connected to the system bus. GDC finds the servo axis
as follows:
Application with ECSxA
Application with ServoPLC
Double-click the servo controller for the flying saw axis and upload the parameter data for the selected drive from
GDC to your PC.
Start
Step 1