Lenze EVS93xx FlyingSaw - Manual (Page 47)

FlyingSaw
Functions
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 3-34
Control/status interface to the higher-level control
In the parameterisable variant the control and status interface is already pre-configured. An
overview of the signal assignments and possibilities for changing the configuration (multiplexer)
of the control/status signals is given below.
The flying saw Prepared Solution can be controlled using a higher-level control over various bus
systems (AIF interface):
Autonomous CAN bus: An additional bus module EMF2171IB or
EMF2172IB
is required in this case for the AIF slot.
CANopen: An additional bus module EMF2175IB is required in this case
for the AIF slot.
DeviceNet: An additional bus module EMF2179IB is required in this case
for the AIF slot.
INTERBUS: An additional bus module EMF2113IB is required in this case
for the AIF slot.
Serial data transmission RS232/RS485: The Prepared Solution can be
controlled using the AIF automation module EMF2102IB by accessing the
control/status codes
PROFIBUS DP: An additional bus module EMF2133IB is required in this
case for the AIF slot.