2 hardware layout, Hardware layout -44, Flyingsaw – Lenze EVS93xx FlyingSaw User Manual
Page 57
Advertising
FlyingSaw
Commissioning the "(Flying Saw)"
Prepared Solution Servo PLC / ECSxA 1.1 EN
page 4-44
4.2 Hardware
layout
The Prepared Solution for the flying saw requires the following hardware configuration:
Attention!
Limit switches represent safety-related devices for a linear axis and must always be wired up
(see also next chapter)!
"Flying saw" drive
Master frequency
Tool
Feed roll
Encoder
Measuring wheel
Limit switch
Feed spindle
Gearbox
Advertising