Lenze EVS93xx FlyingSaw - Manual (Page 56)

FlyingSaw
Commissioning the "(Flying Saw)"
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 4-43
4 Commissioning the "(Flying Saw)"
4.1 Requirements
4.1.1 Required components
Lenze hardware
Product Type designation Hardware version Firmware version
9300ET ServoPLC EVS93xxET 7A or later 6.5 or later
ECSxA ECSxA 4B or later 7.4 or later
PC system bus adapter EMF2177IB 1.3 or later 1.7 or later
Hand-held control unit (keypad
XT) EMZ9371BC
Master frequency connection
Lenze software
Product Type designation Version
Global Drive Loader
(GDLoader) (Freeware) 3.0 or later
Drive PLC Developer Studio
(DDS) ESP-DDS1-P 2.2 or later
Global Drive Control (GDC) ESP-GDC2 4.9 or later
Global Drive Oscilloscope 1.2 or later
Library LenzeMotionControl ESP-SPAC-POS1
Software Package Positioner
4.0
Third-party components
Product Comment/specification
Limit switch (normally closed
contact) Safety-related sensors, operation without limit switches not allowed
Measuring wheel Design as per documentation
Encoder (measuring wheel) Design as per documentation
Only required for programmable variant of the Prepared Solution.