Lenze EVS93xx FlyingSaw - Manual (Page 124)

FlyingSaw
Appendix
 Prepared Solution Servo PLC / ECSxA 1.1 EN 11-2
11.2 Global variables
11.2.1 Global
Global variables (Variable type: VAR_GLOBAL)
Identifier Data type Value/meaning
g_dnScaleWheel DINT Circumference of the measuring wheel
g_dnPulseSensor DINT Encoder pulses from the measuring wheel
g_nFrequencyDFIN INT Input frequency of the measuring wheel
g_nFrequencyDFINNorm INT Standardised input frequency of the measuring wheel
g_bStartlengthCalculator BOOL Start the length calculator
g_dnCutLengthInput DINT Set length
g_dnGapLengthInput DINT Length of the gap
g_dnGapLength_p DINT Length of the gap in increments
g_bMarkenSyncAxtive BOOL Activate mark synchronisation
g_bOffsetUsed BOOL Offset taken into account during a length cut
g_bCalculateNewOffset BOOL Calculate new offset
g_dnTir DINT Flying saw acceleration time
g_bOffsetConsider BOOL Offset value has been taken into consideration
g_dnOffsetLengthCalculator DINT Offset for the length calculator
g_dnOffsetSynchronize DINT Offset for the synchronisation
g_bStartDecelerationSaw BOOL Start of the deceleration ramp
g_nCompensationTrimming INT Increments that are compensated during the synchronisation
g_nCompensationTrimmingUsed INT Compensation completed
g_dnCutterKompensation DINT Width of cut compensation
DelaySynchronSignal INT Delay on the synchronised signal
g_bReset BOOL Reset
g_bResetSync BOOL Reset the synchronisation
g_bExternSetValuesEnable BOOL Switch to external setpoints
g_dnAbortCalcOffset_units DINT Calculation of the offset is interrupted just before synchronising
g_dnAbortCalcOffset_Inc DINT Calculation of the offset is interrupted just before synchronising
g_dnActualValueLengthCalculator DINT Actual length calculator value
g_nSpeedOutSaw INT Flying saw set speed
g_dnPosDiffOutSaw DINT Setpoint for the phase controller
g_bAutomaticFlag BOOL Automatic mode is active
g_bWatchLengthTP BOOL Mark monitoring active
g_ManualProfile Profile Profile for jogging
g_SecondProfile Profile Profile for the movement to the initial position
g_BackProfile Profile Profile for return positioning after a synchronous movement
g_FreeDriveLimitSwitch Profile Move clear from limit switch
g_Profile Profile Profile data
g_Axis Axis Axis data