Flyingsaw – Lenze EVS93xx FlyingSaw User Manual
Page 84
Advertising
FlyingSaw
Commissioning mark-controlled operation
Prepared Solution Servo PLC / ECSxA 1.1 EN
page 6-3
Now change over to the application control word.
To start the mark-controlled operation, set the following bits in the order given:
Bit 04: Change to the "Flying saw mode" state
Bit 10: Activate mark cuts
A top cut is not necessary in mark-controlled operation. The processing is started at the first mark on the
material.
Once bit 10 is activated, a cut is made at the next mark detected.
If you want to leave mark-controlled operation again, then deactivate bit 10. The flying saw is then still in the
"Flying saw mode".
The "Flying saw mode" state is left by resetting the bit 04.
End
Step 4
Advertising