Flyingsaw – Lenze EVS93xx FlyingSaw User Manual
Page 80
FlyingSaw
Commissioning length-controlled operation
Prepared Solution Servo PLC / ECSxA 1.1 EN
page 5-2
You can describe your application for length-controlled operation using the following parameters:
C3007/000 Enter is this parameter the set length of the continuous material that you want to process. This
parameter is entered in the unit [unit]
Now check in the application status word whether the bits for the starting conditions are set correctly.
The following bits must be set for starting the length-controlled operation:
Bit 00 Program initialisation complete.
Bit 01: The axis home position is known.
Bit 04: The axis is in the "Standby" state.
Bit 14: The normalisation factor has been calculated.
Bit 18: The axis is in the initial position.
Step 3