Lenze EVS93xx FlyingSaw - Manual (Page 27)

FlyingSaw
Features of the Prepared Solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 2-14
3. Oversynchronous synchronisation, during this process the master value is measured
by a measuring wheel. The lengths are detected from marks on the material and are
processed.
4. Synchronous synchronisation, during this process the master value is measured by a
measuring wheel. The lengths are detected from marks on the material and are processed.
Can the following physical requirements be taken into account in your application?
You should take into account the following basic design items in your application:
¾ Free travel (distance from initial position – end position) must be sufficient so
that a process sequence can be performed successfully
¾ Maximum cut duration
¾ Maximum velocity of the carriage
¾ Maximum synchronisation velocity
Do you want to process in "parallel" and your process does not require "diagonal"
processing?
During the acceleration to the line speed there is no stopping of the line? (start of flying saw
to hit the synchronous)
?
NO
YES
Your specific application
can be represented via a
modification of the example
solution.
Please contact your Lenze
representative.
?
NO
YES
Your specific application
can be represented via a
modification of the example
solution.
Please contact your Lenze
representative.