5 commissioning length-controlled operation, Commissioning length-controlled operation -1, Flyingsaw – Lenze EVS93xx FlyingSaw User Manual
Page 79: 5commissioning length-controlled operation
FlyingSaw
Commissioning length-controlled operation
Prepared Solution Servo PLC / ECSxA 1.1 EN
page 5-1
5
Commissioning length-controlled operation
Attention!
The commissioning of the length-controlled operation of the Prepared Solution described in the
following relates to the parameterisable variant.
Requirements:
The parameters for the servo controller for the flying saw axis have been specifically set to suit the specific
case, as described in chapter 4.4.3.
The axis is supplied with control voltage using terminals 59 (+24V DC) and 39 (0V) and with power using
terminals L1, L2 and L3.
Initial situation:
• The servo axis is not indicating any error.
• The servo axis is enabled.
• Application control word and application status word have not been specifically set using C4010/0xx and
C4012/0xx.
• The axis has been successfully homed.
Start GDC and perform a search for drive controllers connected to the system bus. GDC finds the drive
controllers connected. These include the drive controller loaded with the FlyingSaw_SPLSC_V0100 project.
Application with ECSxA
Application with ServoPLC
Double-click the controller to be loaded with the FlyingSaw_SPLC_V0100 application.
Now set the specific parameters of your flying saw application
Start
Step 1
Step 2