Lenze EVS93xx FlyingSaw - Manual (Page 48)

FlyingSaw
Functions
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 3-35
Control interface
Meaning
Bit 00: Dependent on the setting in code C4000/000
Bit 01: Dependent on the setting in code C4000/000
Bit 02: Dependent on the setting in code C4000/000
Bit 03: Dependent on the setting in code C4000/000
Bit 04: Dependent on the setting in code C4000/000
Bit 05: Dependent on the setting in code C4000/000
Bit 06: Dependent on the setting in code C4000/000
Bit 07: Dependent on the setting in code C4000/000
C4000/000 = 0: System variables
DCTRL_wAIF1Ctrl and
DCTRL_wCAN1Ctrl are always
set to zero.
Bit 08: Dependent on the setting in code C4000/000
Bit 09: Dependent on the setting in code C4000/000
Bit 00: Dependent on the setting in code C4000/000
Bit 11: Dependent on the setting in code C4000/000
Bit 12: Dependent on the setting in code C4000/000
Bit 13: Dependent on the setting in code C4000/000
Bit 14: Dependent on the setting in code C4000/000
Wo
rd
0
System control
word
Bit 15: Dependent on the setting in code C4000/000
C4000/000 = 1, 2, 3:
C4000/000 = 4, 5, 6:
The drive control word is copied to
DCTRL_wCAN1Ctrl;
DCTRL_wAIF1Ctrl is set to zero.
The drive control word is copied to
DCTRL_wAIF1Ctrl;
DCTRL_wCAN1Ctrl is set to zero.
Wo
rd
1
Data word 1
(not used)
Bit 00: Start of homing
Bit 01: Homing switch
Bit 02: Manual control in positive direction
Bit 03: Manual control in negative direction
Bit 04: Start automatic
Bit 05: Synchronisation mode (TRUE = synchronous, FALSE = oversynchronous)
Bit 06: Trigger top cut
Bit 07: Cut done signal
Bit 08: Start make gap
Bit 09: Move to initial position
Bit 10: Activate mark cut
Bit 11: Reset error
Bit 12: Set user error
Bit 13: Increment scrap counter
Bit 14: Reset top cut counter
Wo
rd
2
Bit 15: Reset cut counter
Bit 16: Reset scrap counter
Bit 17: Reset counters (global all)
Bit 18: (not used)
Bit 19: CINH
Bit 20: Selection of the master frequency source, TRUE = simulation (code), FALSE = DFIN (X9)
Bit 21: (not used)
Bit 22: (not used)
Bit 23: (not used)
Bit 24: (not used)
Bit 25: (not used)
Bit 26: (not used)
Bit 27: (not used)
Bit 28: (not used)
Bit 29: (not used)
Bit 30: (not used)
Wo
rd
3
Applicat
ion cont
rol word
Bit 31: (not used)