Lenze EVS93xx FlyingSaw - Manual (Page 50)

FlyingSaw
Functions
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 3-37
Click the code and select the required control bit.
Example: To control the positive manual control on the X axis bit 31 must be used. Set C4010/008 = 31 and
accept using Ok.
If the configuration of further control bits is to be changed, continue with step 1.
Save the modified settings safe against mains failure using C0003/000 = 1.
End
?
YES ⇒ 1
NO
Step 3
Step 2