Lenze EVS93xx FlyingSaw - Manual (Page 97)

FlyingSaw
Dimensioning aspects
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 9-4
9.4 Master frequency source Servo / Servo PLC
Process example for master frequency coupling
feedconstant [units/r]
gearbox - gearbox nominator
- gearbox denominator
x9
Feedback
x7/x8
x10
Feedback
x7/x8
DFOUT constant (C0030) [inc/r]
feedconstant[units/r]
gearbox
The normalisation factor is calculated as follows:
Parameters for normalising controller 1:
• Gearbox factor numerator
• Gearbox factor denominator
• Feed constant [units/r]
• DFOUT constant (C0030) [inc/r]