Lenze EVS93xx FlyingSaw - Manual (Page 37)

FlyingSaw
Features of the Prepared Solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 2-24
The distance between the software limit positions must not be more than 2 31 -1 increments.
Possible settings: Code
Default Selection
Comments
C3223 3600.0000 0.0000... {0.0001
[units]}
... 214748.0000 Definition of the positive software limit
Comment: software limits are only active if the home position
for the axis is known and is not set to 0.
C3224 -3600.0000 -214748.0000... {0.0001
[units]}
... 0.0000 Definition of the negative software limit
Comment: software limits are only active if the home position
for the axis is known and is not set to 0.
TIP!
If a 0 is entered for the software limit positions, the software limit positions are deactivated.