2 configuration of the ecs user interface, 1 default setting of the ecs hardware inputs, Configuration of the ecs user interface -3 – Lenze EVS93xx FlyingSaw User Manual
Page 91: Default setting of the ecs hardware inputs -3, Flyingsaw, Program extensions/supplements
FlyingSaw
Program extensions/supplements
Prepared Solution Servo PLC / ECSxA 1.1 EN
page 8-3
8.2 Configuration
of
the ECS user interface
8.2.1
Default setting of the ECS hardware inputs
Digital inputs
(X6)
terminal signal
value/meaning
Controller enable
0V Inhibit servo controller
28
24V Enable servo controller
E1
DFIN_bTPReceived_b Touch probe input for mark-controlled synchronisation.
Note: The code C0428/000 must always be set to the value 1 so that the mark is detected using input E1
Signal from the homing switch
The signal is only relevant for the homing modes 0, 1, 2, 3, 4 and 5 – you will find further information on the
individual homing modes in chapter 2.12.1
E2
g_bHomingMark
24V => 0V Homing switch
Signal from the positive limit switch
0V Positive limit switch actuated
E3
g_bLimitSwitchPos
24V Positive limit switch not actuated
Signal from the negative limit switch
0V Negative limit switch not actuated
E4
g_bLimitSwitchNeg
24V Negative limit switch not actuated
Analog inputs
(X6)
terminal signal
value/meaning
1, 2
(not used)
3, 4
(not used)
Master frequency
input (X8)
terminal signal
value/meaning
X8
DFIN_nIn_v
Input of the master speed as phase difference signal:
The number of increments in the signal present on X8 can be set in the parameters using code C0425/000, however
a value for C0425/000 = 6 (16384[incr./rev]) should always be used to ensure the greatest possible resolution for the
master position.