Flyingsaw, Description of the function blocks – Lenze EVS93xx FlyingSaw User Manual
Page 105
FlyingSaw
Description of the function blocks
Prepared Solution Servo PLC / ECSxA 1.1 EN
10-7
Outputs
(Variable type: VAR_OUTPUT)
Identifier Data
type
Value/meaning
nFrequencyDFIN_v
INT
Output of the frequency for the master value. In the simulation mode the value defined on the input
SimulationMasterFrequency_v is output. Otherwise the master value from the input
MasterFrequency_DFIN_nIn_v. The output variable is also evaluated using the filter time from the
input nFilteringDFIN .
The filtering is only active if the master value is defined using input X9 on the servo axis. The filter time
is not taken into account in the simulation.
nFrequencyDFINNorm_v INT
Output
of
the normalised master frequency. In addition to the output variable nFrequencyDFIN_v this
output is adapted to the axis parameters using the normalisation factor.
The filtering is only active if the master value is defined using input X9 on the servo axis. The filter time
is not taken into account in the simulation.