Lenze EVS93xx FlyingSaw - Manual (Page 95)

FlyingSaw
Dimensioning aspects
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 9-2
9.2 Axis normalisation
For the normalisation of the flying saw, two concepts for a master frequency source will be
considered.
1. Master frequency source measuring wheel
2. Master frequency source Servo / Servo PLC (master frequency coupling)
9.3 Master frequency source measuring wheel
Process example with measuring wheel for master frequency determination
measuring wheel: - measuring wheel [units/r]
- feedconstant[inc/r]
feedconstant [units/r]
gearbox - gearbox nominator
- gearbox denominator
engine
drive 93xx Servo PLC ET
x9
Feedback
DFIN constant (C0425) [inc/r]
x7/x8