Flyingsaw – Lenze EVS93xx FlyingSaw User Manual
Page 70
FlyingSaw
Commissioning the "(Flying Saw)"
Prepared Solution Servo PLC / ECSxA 1.1 EN
page 4-57
Parameterise the homing next:
Set the following codes for setting the parameters:
C3213/000
= Homing mode
C3225/000
= Homing offset (reference: 65536 = one motor revolution)
C3242/000
= Homing speed in [rpm]
C3252/000
= Acceleration and deceleration ramps for the homing in [s]
TIP!
You will find further information on the homing in chapter 2.12.1
Parameterise the settings for manual jog (short setup Î profile settings):
Set the following codes for setting the parameters for manual control:
C3100/000
= Velocity for manual control in [units/s]
C3101/000
= Acceleration for manual control in [units/s^2]
C3102/000
= Deceleration for manual control in [units/s^2]
Step 7
Step 6