3 user-defined error messages, User-defined error messages -20, Flyingsaw – Lenze EVS93xx FlyingSaw User Manual
Page 142: Appendix
Advertising
FlyingSaw
Appendix
Prepared Solution Servo PLC / ECSxA 1.1 EN
11-20
11.4.3
User-defined error messages
Error
number
Error code
Cause
Remedy
500
UserError
The related input bUser
Error on the function block
ErrorHandling has been activated by a
positive edge. The signal causing the
error has been programmed on the
user's side.
Evaluate the logic providing the signal on the input
bUserError.
Advertising