Lenze EVS93xx FlyingSaw - Manual (Page 81)

FlyingSaw
Commissioning length-controlled operation
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 5-3
Now change over to the application control word.
To start the length-controlled operation, set the following bits in the order given:
Bit 04: Change to the "Flying saw mode" state
Bit 06: Perform a top cut
After bit 06 is set in the application control word, the axis synchronises to the line speed. The material is
processed once synchronicity has been achieved.
Reset bit 06.
When the processing is complete and the flying saw axis is to move back to the initial position, activate bit 07.
This "cut done signal" causes the axis to decelerate and subsequent positioning at the initial position.
By performing the top cut you have started length-controlled operation. All other start signals for synchronising
are generated by the length calculator which calculates equidistant lengths.
If you want to stop operation, bit 04 must be reset. The axis is then back in the "Standby" state. A change to
length-controlled operation can be made at any time as described in step 4.
End
Step 4