Lenze EVS93xx FlyingSaw - Manual (Page 38)

FlyingSaw
Features of the Prepared Solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 2-25
2.17 Moving clear from a limit switch
If the drive moves to a limit switch in the negative or positive direction, then it is possible to
retract the actuated limit switch in the opposite direction by using the inching mode.
Example:
The negative limit switch (E2) has been reached and triggers the error with the number 401.
The limit switch can be retracted using the "inching positive" function and the error is reset
automatically. The axis automatically remains stationary after retracting.
The same applies to the software limit positions. The software limit position to which the drive
has moved, in the positive or negative direction, can also be retracted in the opposite direction
using the inching mode.
 TIP!
After a limit switch that has been approached is retracted, the axis stops automatically and
changes to the "Standby" state
 Attention!
For the retracting function after a damping process, hardware limit switches may not be
overtravelled! If limit switches are overtravelled, the retracting function is deactivated.
Manual Jog Pos