Lenze EVS93xx FlyingSaw - Manual (Page 85)

FlyingSaw
State machine of the Prepared Solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 7-1
7 State machine of the Prepared Solution
7.1 Overview
The states for the Prepared Solution are represented by a so-called state machine. The state
machine indicates a total of 11 states between which it is possible to change as follows:
The individual states are represented in the Prepared Solution using a global variable g_wState
(ENUM) and also displayed to the operator using the code C3990/000.
Possible settings: Code
Default Selection
Comments
C3990 - 1:
10:
20:
21:
22:
30:
40:
41:
42:
43
50:
100: trouble
standby
manual mode
manual jog positive
manual jog negative
homing operation
flying saw operation
head cut
length cut
TP cut
positioning operation
initialisation Error state
Standby state Manual operation
Positive manual control
Negative manual control
Homing active
Automatic "flying saw"
Top cut is being performed
Length cut active
Mark cut active
Move to initial position
Initialisation
TIP!
The code C3990/000 is permanently linked to the parameterisable variant in the GDC Monitor
window such that the states of the Prepared Solution can be easily followed.