Figure 7.2, Test with a single-phase current source – Rockwell Automation 825 Smart Motor Manager User Manual User Manual
Page 132
Advertising
7-6 Testing and Maintenance
Publication 825-UM001B-EN-P January 2001
Test with Single-Phase Current Source
The test with a 3-phase current source described on page
can also be performed with a
single-phase source. To do this, the earth (ground) fault protection by the Holmgreen method
must be switched off.
Figure 7.2 Test with a Single-Phase Current Source
ATTENTION
!
This test should be performed only by qualified personnel.
IMPORTANT
The test current may not flow through the core balance current
transformer.
825-MCM
825-M
1
3
5
2
4
6
A
M
3 ~
,
e
Connection
Connection
Advertising