Rockwell Automation 825 Smart Motor Manager User Manual - Manual (Page 35)

Functions 3-2
Publication 825-UM001B-EN-P January 2001
Set Values
The parameters “Main Settings” and “Special Settings” must be programmed for every
application. The other parameters (e.g., “High Overload”, “Asymmetry”) have factory-set
values, which are correct for most applications.
Table 3.B Set Values Overview
Parameter List
Option
Card
Cat. No.
Page Parameter List
Option
Card
Cat. No.
Page
THERMAL TRIP — 5-4 THERMAL RESET LEVEL — 5-10
THERMAL WARNING — 5-4 COOLING CONSTANT RATIO — 5-10
ASYMMETRY TRIP — 5-5 PTC TRIP 825-MST 5-10
ASYMMETRY WARNING — 5-5 PTC RESET 825-MST 5-10
OVERCURRENT TRIP — 5-5 CONTROL INPUT #1 5-10
OVERCURRENT WARNING — 5-5 DELAY AUX REL # 2
825-MST
5-10
EARTH FAULT PROTECTION — 5-6 SPEED SWITCH 5-11
EARTH FAULT HOLMGREEN TRIP — 5-6 DISABLE FUNCTION 5-11
EARTH FAULT CORE TRIP 825-MST 5-7 CONTROL INPUT #2 5-12
EARTH FAULT CORE WARNING 825-MST 5-7 DELAY AUX REL #3 825-MST 5-12
SHORT CIRCUIT PROTECTION 825-MST 5-7 NEW FULL LOAD CURRENT 5-12
UNDERLOAD TRIP — 5-8 PHASE REVERSAL TRIP
825-MLV
5-13
UNDERLOAD WARNING — 5-8 PHASE LOSS TRIP 5-13
STAR DELTA STARTING 825-MLV 5-8 PT100 PROTECTION
825-MMV 5-13
WARM STARTING — 5-9 PT100 RESET/WARNING
START INHIBIT — 5-11 OUTPUT 4…20 mA 825-MST 5-15
START CONTROL — 5-9 STATION NUMBER — 5-16
MAIN RELAY CONNECTION — 5-10 REL #2-3 VIA COM — 5-16
ALARM RELAY CONNECTION — 5-10 CLEAR RECORDED VALUES — 5-16
THERMAL RESET — 5-10 FACTORY SETTINGS — 5-16
ATTENTION
!
All parameters can be set, including those functions associated with
option boards that have not been mounted in the device. However,
these warning and trip functions are not operational unless the
corresponding option board is installed.