Rockwell Automation 1756-XXXX ControlLogix Analog I/O Modules - Manual (Page 194)

194 Publication 1756-UM009C-EN-P - December 2010
Chapter 9 Install ControlLogix I/O Modules
Recommendations for Wiring Your RTB
We recommend you follow these guidelines when wiring your RTB.
1. Begin wiring the RTB at the bottom terminals and move up.
2. Use a tie to secure the wires in the strain relief (bottom) area of the RTB.
3. Order and use an extended-depth housing (catalog number 1756-TBE)
for applications that require heavy gauge wiring.
Assemble the RTB
and the Housing Removable housing covers the wired RTB to protect wiring connections when
the RTB is seated on the module.
1. Align the grooves at the bottom of each side of the housing with the
side edges of the RTB.
2. Slide the RTB into the housing until it snaps into place.
1
4
3
2
3
2
20858-M
Item Description
1 Housing cover
2 Groove
3 Side edge of RTB
4 Strain relief area
IMPORTANT
If additional wire routing space is required for your application,
use the extended-depth housing, catalog number 1756-TBE.