Rockwell Automation 1756-XXXX ControlLogix Analog I/O Modules - Manual (Page 220)

220 Publication 1756-UM009C-EN-P - December 2010
Chapter 10 Configure ControlLogix Analog I/O Modules
2. Do one of the following:
• Click Apply to store a change but stay on the dialog box to choose
another tab.
• Click OK to apply the change and close the dialog box.
• Click Cancel to close the dialog box without applying changes.
Configuration Tab
The Configuration tab lets you program information on a
channel-by-channel basis. The number of channels depends on the selected
output module.
Use Unicast Connection on EtherNet/IP Displays only for analog modules using
RSLogix5000 software version 18 or
later in a remote EtherNet/IP chassis.
Use the default checkbox if there are no
other controllers in ’Listen’ mode.
Clear the box if there are other
’listening’ controllers in the system.
Module Fault The fault box is empty if you are offline.
The type of connection fault appears in
the text box if a fault occurs when the
module is online.
Field Name Description