Rockwell Automation 1756-XXXX ControlLogix Analog I/O Modules - Manual (Page 226)

226 Publication 1756-UM009C-EN-P - December 2010
Chapter 10 Configure ControlLogix Analog I/O Modules
Edit Configuration After you have set configuration for a module, you can review and change your
choices in the RSLogix 5000 programming software. You can download the
data to the controller while online. This is called dynamic reconfiguration.
Follow these steps to edit a module’s configuration.
1. On the Controller Organizer, right-click an I/O module and choose
Properties.
The Module Properties dialog box appears.
2. Click a tab that contains the fields that you want to edit.
3. Make any changes, and then click OK.