Rockwell Automation 1756-XXXX ControlLogix Analog I/O Modules - Manual (Page 217)

Publication 1756-UM009C-EN-P - December 2010 217
Configure ControlLogix Analog I/O Modules Chapter 10
2. After the channels are configured, do one of the following:
• Click Apply to store a change but stay on the dialog box to choose
another tab.
• Click OK to apply the change and close the dialog box.
• Click Cancel to close the dialog box without applying changes.
IMPORTANT
The module sends back temperature values over the entire
sensor range as long as the High signal value equals the
High engineering value and the Low signal value equals
the Low engineering value.
For the example above, if:
High signal = 78.0 °C , High engineering must = 78.0.
Low signal = -12.0 °C , Low engineering must = -12.0