Rockwell Automation 1756-XXXX ControlLogix Analog I/O Modules - Manual (Page 199)

Publication 1756-UM009C-EN-P - December 2010 199
Chapter
10
Configure ControlLogix Analog I/O Modules
Introduction You must configure your module upon installation. The module will not work
until it has been configured.
In most cases, you will use RSLogix 5000 programming software to configure
your analog I/O module. The programming software uses default
configurations, such as RTS, RPI, and so forth, to get your I/O module to
communicate with the owner-controller.
However, there are situations in which you might want to modify the default
settings. You can maintain custom settings on tabs from the Module
Properties dialog box. This section provides step-by-step instructions for
creating default and custom configurations
Topic Page
Full Configuration Profile Diagram 201
Create a New Module 202
Modify Default Configuration for Input Modules 207
Configure the RTD Module 215
Configure the Thermocouple Modules 216
Modify Default Configuration for Output Modules 218
Download Configuration Data to the Module 225
Edit Configuration 226
Reconfigure Module Parameters in Run Mode 227
Reconfigure Parameters in Program Mode 229
Configure I/O Modules in a Remote Chassis 230
View Module Tags 232