Install the removable terminal block – Rockwell Automation 1756-XXXX ControlLogix Analog I/O Modules User Manual
Page 195
Publication 1756-UM009C-EN-P - December 2010
195
Install ControlLogix I/O Modules Chapter 9
Install the Removable
Terminal Block
These steps show how to install the RTB onto the module to connect the
wiring.
Before installing the RTB, make certain:
• field-side wiring of the RTB has been completed.
• the RTB housing is snapped into place on the RTB.
• the RTB housing door is closed.
• the locking tab at the top of the module is unlocked.
1.
Align the top, bottom, and left side guides of the RTB with the guides
on the module.
2.
Press quickly and evenly to seat the RTB on the module until the latches
snap into place.
WARNING
When you connect or disconnect the removable terminal block
(RTB) with field-side power applied, an electrical arc can occur.
This could cause an explosion in hazardous location
installations. Be sure that power is removed or the area is
nonhazardous before proceeding.
Top Guide
Bottom Guide
20853-M