Rockwell Automation 1756-XXXX ControlLogix Analog I/O Modules - Manual (Page 210)

210 Publication 1756-UM009C-EN-P - December 2010
Chapter 10 Configure ControlLogix Analog I/O Modules
2. Do one of the following:
• Click Apply to store a change but stay on the dialog box to choose
another tab.
• Click OK if you are finished making changes.
Configuration Tab
The Configuration tab on the Module Properties dialog box lets you program
information on a channel-by-channel or module-wide basis. The number of
channels depends on the selected input module.
Use Unicast Connection on EtherNet/IP Displays only for analog modules using
RSLogix5000 software version 18 or
later in a remote EtherNet/IP chassis.
Use the default checkbox if there are no
other controllers in ’Listen’ mode.
Clear the box if there are other
’listening’ controllers in the system.
Module Fault The fault box is empty if you are offline.
The type of connection fault appears in
the text box if a fault occurs when the
module is online.
Field Name Description