Rockwell Automation 7763 Medium Voltage OneGear SMC Flex Motor Controller (10-15 kV) - Manual (Page 61)

Rockwell Automation Publication 7760-UM001D-EN-P - October 2014 61
Chapter
3
Programming
Overview This chapter provides a basic understanding of the programming keypad built
into the SMC Flex controller. This chapter also describes programming the
controller by modifying the parameters.
Note: This User Manual pertains to the OneGear 10…15 kV SMC Flex control
modules with version 6.003 firmware or later.
Keypad Description The keys found on the front of the SMC Flex controller are described below.
Table 7 - SMC Flex Controller Keys
Note: For ease of programming values, after using the Enter key to edit, use the
Sel key to jump to the digit that needs to be modified, then use the arrow keys to
scroll through the digits.
Programming Menu Parameters are organized in a three-level menu structure for straightforward
programming.
Figure 33 details the programming menu structure and the three-
level hierarchy.
In order to change parameters, the controller must be in the STOP mode, and the
control voltage must be present.
Key Action Description
Escape Exit a menu, cancel a change to a parameter value, or acknowledge a fault/alarm.
Select Select a digit, select a bit, or enter edit mode in a parameter screen.
Will get to menu to change the language being displayed.
Up/Down Arrows Scroll through options increase/decrease a value, or toggle a bit.
Enter Enter a menu, enter edit mode in a parameter screen, or save a change to a parameter value.
Esc Esc
Lang
Sel Sel