Rockwell Automation 7763 Medium Voltage OneGear SMC Flex Motor Controller (10-15 kV) - Manual (Page 92)

92 Rockwell Automation Publication 7760-UM001D-EN-P - October 2014
Chapter 7 Communications
SMC Flex Bit Identification
Table 32 - Logic Status Word
Bit #
Status Description
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
X Enabled
1 – Control Power Applied
0 – No Control Power
X Running
1 – Power Applied to Motor
0 – Power not Applied to Motor
X Phasing
1 – ABC Phasing
0 – CBA Phasing
X
Phasing
Active 1 – 3-phase is valid
0 – No valid 3-phase is detected
X
Starting
(Accel) 1 – Performing a Start Maneuver
0 – Not performing a Start Maneuver
X
Stopping
(Decel) 1 – Performing a Start Maneuver
0 – Not performing a Start Maneuver
X Alarm
1 – Alarm Present
0 – No Alarm Present
X Fault
1 – Fault Condition Exists
0 – No Fault Condition
X At Speed
1 – Full Voltage Applied
0 – Not Full Voltage Applied
X
Start/
Isolation 1 – Start/Isolation Contactor Enabled
0 – Start/Isolation Contactor Disabled
X Bypass
1 – Bypass Contactor Enabled
0 – Bypass Contactor Disabled
X Ready
1 – Ready
0 – Not Ready
X X
Option 1
Input 1 – Input Active
0 – Input Inactive
X X
Option 2
Input 1 – Input Active
0 – Input Inactive
— — Bits 12 to 15 – Not Used