Rockwell Automation 7763 Medium Voltage OneGear SMC Flex Motor Controller (10-15 kV) - Manual (Page 77)

Rockwell Automation Publication 7760-UM001D-EN-P - October 2014 77
Chapter
5
Options
Overview The SMC Flex controller offers a variety of unique control programming and
communication options that provide enhanced capabilities. (See
Chapter 1 for
brief descriptions of each option.)
Note: Only one option can reside in a controller.
Human Interface Module The control buttons available with the Bulletin 20HIM Human interface
modules are compatible with the SMC Flex controller’s control options. The
following table details the functionality of each button with regards to each
option.
Notes:
1. The logic mask port must be enabled prior to initiating control commands
to the SMC Flex controller. Refer to
Control Enable on page 90 for
instructions.
2. The control terminals must be wired according to Figure 25 on page 45 or
Figure 26 on page 46 .
Table 23 - Human Interface Module Operations
Option Action Operation
Standard
Soft Stop
Current Limit
Full Voltage
Linear Speed
The green start button, when pressed, will commence motor acceleration to full speed.
The red stop button, when pressed, will provide a coast stop, and/or reset a fault.
The jog button, when pressed, will initiate the programmed maneuver.
Preset
Slow Speed
The green start button, when pressed, will commence motor acceleration to full speed.
The red stop button, when pressed, will provide a coast stop.
The jog button is not active for Preset Slow Speed.
Note: Slow Speed cannot be operated via the HIM.
Pump Control
II
O O
Jog Jog
II
O O
Jog Jog