Rockwell Automation 7763 Medium Voltage OneGear SMC Flex Motor Controller (10-15 kV) - Manual (Page 87)

Rockwell Automation Publication 7760-UM001D-EN-P - October 2014 87
Communications Chapter 7
Table 27 - Operator Interface Keys
All other controls available with the various human interface modules are non-
functional with the SMC Flex controller.
Connecting the Human Interface Module to the Controller
Figure 38 shows the connection of the SMC Flex controller to a human interface
module. Table 28 provides a description of each port.
Note: The SMC Flex only supports the use of DPI communication modules and
DPI HIM Modules. Scanport devices are not supported by the SMC Flex.
See Figure 25 on page 45 or Figure 26 on page 46 for the control wiring diagram
that enables start-stop control from a human interface module.
Key Name Description
Start
The green start button, when pressed, will begin motor operation. (Proper setup of HIM port is required.)
Stop
The red stop button, when pressed, will halt motor operation and/or reset a fault.
Jog
The jog button is active only when a control option is present. Pressing the jog button will initiate the option
maneuver (for example: Pump Stop).
II
O O
Jog Jog
ATTENTION: The Bulletin 20-HIM interface module's stop push button is not
intended to be used as an emergency stop. Refer to the applicable standards for
emergency stop requirements.
ATTENTION: The external HIM has a similar programming operation to the
built-in programmer, but note that differences do exist.