Rockwell Automation 7763 Medium Voltage OneGear SMC Flex Motor Controller (10-15 kV) - Manual (Page 78)

78 Rockwell Automation Publication 7760-UM001D-EN-P - October 2014
Chapter 5 Options
Pump Control
The green start button, when pressed, will commence motor acceleration to full speed.
The red stop button, when pressed, will provide a coast stop, and/or reset a fault.
The jog button, when pressed, will initiate a pump stop maneuver.
Braking Control
(1)
Smart Motor Braking
The green start button, when pressed, will commence motor acceleration to full speed.
The red stop button, when pressed, will provide a coast stop, and/or reset a fault.
The jog button, when pressed, will initiate a pump stop maneuver.
Accu-Stop
The green start button, when pressed, will commence motor acceleration to full speed.
The red stop button, when pressed, will provide a coast stop, and/or reset a fault.
With a “stopped” status, the jog button, when pressed, will initiate slow speed motor operation. From an “at
speed” condition, the jog button, when pressed, will initiate braking to slow speed operation. The controller
will maintain slow speed operation as long as the jog button is pressed.
Slow Speed with Braking
The green start button, when pressed, will commence motor acceleration to full speed.
The red stop button, when pressed, will provide a coast stop, and/or reset a fault.
The jog button will initiate a brake stop.
Note: Slow Speed cannot be operated via the HIM.
(1) Braking Control is not offered for standard use in MV applications. Please consult factory for further assistance.
Option Action Operation
II
O O
Jog Jog
II
O O
Jog Jog
II
O O
Jog Jog
II
O O
Jog Jog
ATTENTION: The Bulletin 20-HIM interface module’s stop push button is not
intended to be used as an emergency stop. Refer to the applicable standards for
emergency stop requirements.