Rockwell Automation 7763 Medium Voltage OneGear SMC Flex Motor Controller (10-15 kV) - Manual (Page 67)

Rockwell Automation Publication 7760-UM001D-EN-P - October 2014 67
Programming Chapter 3
Parameter Modification All parameters are modified using the same method. The basic steps to
performing parameter modification are described below.
Notes:
1. Parameter values modified while the motor is operating are not valid until
the next start sequence begins.
2. If the password is set, parameters cannot be adjusted without logging in.
3. Use the Sel key to highlight a single digit.
Table 11 - Parameter Modification Procedure
Description Action Display
(2)
—
1. Press the ESC key to go from the status display to the Main menu. —
2. Scroll with the Up/Down keys until the Preferences option is highlighted.
3. Press the Enter key to access the Parameter menu.
4. Scroll with the Up/Down keys until the option you want to use (Monitoring, Motor
Protection, etc.) is highlighted. For this example, Set Up will be used.
5. Press Enter to select the Set Up group. —
6. Scroll to Basic Set Up and press Enter. (1)
7. Scroll to the Starting Mode parameter by using the Up/Down keys, and press Enter.
8. Press Enter to select the option. Scroll to the option of your choice by using the Up/
Down keys. For this example, we will choose Current Limit.
9. Press the Enter key to accept the new setting. —
10.Scroll to the next parameter by using the Down key. Continue the process until all
desired settings are entered.
(1) The SMC Option advises the user if any control option (i.e., Pump Control) is resident. This parameter is factory set and cannot be modified by the user.
(2) To complete the programming process, re-enter the Main Menu mode to log out. This will eliminate unauthorized access to the programming system.
Esc Esc