Rockwell Automation 7763 Medium Voltage OneGear SMC Flex Motor Controller (10-15 kV) - Manual (Page 65)

Rockwell Automation Publication 7760-UM001D-EN-P - October 2014 65
Programming Chapter 3
Password The SMC Flex Controller allows the user to limit access to the programming
system through password protection. This feature is disabled with a factory-set
default of 0. To modify the password or login after a password is programmed,
complete the procedure below.
Table 9 - Password Modification Procedure
Note: If you lose or forget the password, contact your nearest Rockwell
Automation sales office. You can also call Rockwell Automation Medium Voltage
Product Support at 1-519-740-4790 for assistance.
40 Slow Speed Cur 85 Emergency Run 130 Start Time 2E
41 Slow Accel Cur 86 Current Loss 131 Stop Time E
42 Slow Running Cur 87 Logic Mask 132 Option 1 Input
43 Stopping Current 88 Data In A1 133 Stop Input
44 Overload Class 89 Data In A2 134 Elapsed Time 2
45 Service Factor 90 Data In B1
(1) Do not change these parameters from the default settings.
(2) Pump Control module only – see Troubleshooting section for guidance.
(3) Brake module only – Consult factory.
Parameter No. Description Parameter No. Description Parameter No. Description
Description Action Display
— —
1. Press the ESC key to go from the status display to the Main menu.
2. Scroll with the Up/Down keys until the Preferences option is highlighted.
3. Press the Enter key to access the Preferences menu.
4. Scroll with the Up/Down keys until the Change Password option is highlighted. —
5. Press the Enter key.
6. Press the Up/Down keys to enter the desired number. If you are modifying the
password, make a note of it as displayed.
—
7. Verification of the new password is required. Press the Enter key. —
8. Press the Enter key after you have completed modifying the password.
(1)
(1) To complete the programming process, re-enter the Main Menu mode to log out. This will eliminate unauthorized access to the programming system.
Esc Esc