Rockwell Automation 7763 Medium Voltage OneGear SMC Flex Motor Controller (10-15 kV) - Manual (Page 81)

Rockwell Automation Publication 7760-UM001D-EN-P - October 2014 81
Chapter
6
Diagnostics
Overview This chapter describes the fault diagnostics of the MV SMC Flex controller.
Further, this section describes the conditions that cause various faults to occur.
Protection Programming
Many of the protective features available with the SMC Flex controller can be
enabled and adjusted through the programming parameters provided. For further
details on programming, refer to the
Motor Protection section in Chapter 3 ,
Programming.
Fault Display The SMC Flex controller comes equipped with a built-in three-line, 16-character
LCD. The LCD displays the fault message on the first line, the fault code on the
second line, and the fault description on the third line.
Figure 36 - Fault Display
Note: The fault display will remain active as long as control power is applied. If
control power is cycled, the fault will be cleared, the controller will re-initialize,
and the display will show a status of "Stopped".
Note: You can hit ESC to get to another programming/diagnostic list, but the
SMC Flex will still be in a faulted state.
Clear Fault You can clear a fault using any of several methods:
Press and hold the front panel “ESC” key for 3 seconds.
IMPORTANT Resetting a fault will not correct the cause of the fault condition. Corrective
action must be taken before resetting the fault.