Chapter 40, 1797-tb3 flex ex terminal base unit, Module installation – Rockwell Automation 1797-XXX FLEX Ex System Certification Reference Manual User Manual
Page 183: Installation in division 1/ zone 1, Chapter
![background image](/manuals/580372/183/background.png)
1
Publication 1797-6.5.6 - June 2005
Chapter
40
1797-TB3 FLEX Ex Terminal Base Unit
Module Installation
You will need to rotate the keyswitch (1) to the correct position depending on
the module. Refer to the module’s installation instructions for more
information. Do not change the position of the keyswitch after wiring the
terminal base unit.
Make certain that you only connect terminal base units to other intrinsically
safe system modules or adapters to maintain the integrity of the
intrinsically-safe backplane.
Installation in Division 1/
Zone 1
Do not remove the flexbus cover (8) on the right-most terminal base unit.
0
1
2 3 4 5
6 7
8 9 10 11 12 13 14 15
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33
34 35 36 37 38 39 40 41 42 43
45 46 47 48 49 50
44
51
42332
Label here
(8) flexbus
cover
(1) keyswitch
41307