Rockwell Automation 6180 Industrial Computers - Manual (Page 103)

Adding and Removing Data Adding and Removing Data Adding and Removing Data Adding and Removing Data
Storage Drives
Storage Drives Storage Drives Storage Drives
This chapter describes how to remove and install data storage devices.
The section gives instructions on how to install or remove a hard disk
drive from the 6180 Industrial Computer.
Internal components may be damaged by electrostatic discharge (ESD).
Make sure you wear a grounding strap whenever handling circuit boards,
memory modules or other internal components.
ATTENTION: Wear a wrist strap (well grounded) and
perform work in a static safe environment. Electrostatic
discharge can damage the 6180 Computer and
components.
ATTENTION: Be careful when setting a drive down on
hard surfaces, to avoid damage due to shock or vibration.
Observe the following precautions:
•
Always handle the drive by its metal frame.
•
Avoid touching the exposed printed circuit board and components.
•
Store a drive in an anti–static bag when it is not installed.
•
Avoid touching the cable connectors.
•
Never disconnect or connect a drive with power turned on.
To remove a hard drive:
1. Disconnect power from the 6180 Computer.
ATTENTION: Disconnect all power from the 6180
Computer before adding and removing components.
Failure to disconnect power could result in severe
electrical shock or damage to the 6180 Computer
Chapter Chapter Chapter Chapter
8
Chapter Objective
Installing and Removing
Data Storage Drives