Rockwell Automation 6180 Industrial Computers User Manual
Page 112
9–6
Adding and Removing Power Supplies
Publication 6180-6.0
160 Watt Supply - Check AC Voltage Selection Switch:
Note:
Voltage selection on the 210 and 180 Watt supply is
automatic. The following instructions only apply to the 160
Watt supply.
If a power cord is being connected for the first time, a protective warning
label covers the power supply connector. This warning label reminds
you to set the proper input voltage and must be removed before the
power cord is inserted.
ATTENTION: Check voltage selection before applying
power (160 Watt supply only).
Figure 9- 4
200W 24V DC Input Power Supply Connection
Proper Earth grounding of the product chassis is required when using
the 200W DC input power supply. Keep the grounding wire short, and
preferably use braided cable, in order to reduce the impedance of this
connection as much as possible. Improper grounding will result in
reduced immunity to line transients and surges on the DC input power
lines.
It is recommended that the 24V DC power be supplied via 10 or 12
gauge wiring kept as short as possible, preferably less than 3 meters in
length.