Rockwell Automation 6180 Industrial Computers - Manual (Page 110)

9–4 Adding and Removing Power Supplies
Publication 6180-6.0
Figure 9- 2
To install the power supply:
ATTENTION: Risk of Electrical Shock. Do not use
screws exceeding 0.438 inches (11.125 mm). Screws that
are longer than recommended may come in contact with
voltage sources within the power supply.
1. Position the power supply in the chassis and secure with the 5
mounting screws. Torque screws to 6–8 in–lbs (0.7 to 0.9 N•m).
2. Connect the power supply cable connectors to the processor board
and other internal components. The connectors are keyed so they
cannot be installed the wrong way, do not force connectors.