Rockwell Automation 6180 Industrial Computers - Manual (Page 61)

Initial Operation a Initial Operation a Initial Operation a Initial Operation and Setup nd Setup nd Setup nd Setup
This chapter provides information on:
•
Operating recommendations
•
Bootup sequence
•
System reset and power on/off buttons
•
System hot keys
We recommend these operating guidelines:
•
Avoid turning the system on and off frequently.
•
Never turn the system off when the hard drive indicator light is
illuminated.
•
After shutting the system off, do not turn it back on again until the
hard drive has come to a complete stop (about 30 seconds).
•
If using an external monitor, turn on the monitor first.
•
Always use the proper power down procedures as required by your
operating system such as the Shut Down command in the Microsoft
Windows operating system.
•
Do not operate the 6180 Computer without the back panel installed.
An electrical shock hazard exists. In addition, removing the back
panel disrupts air flow and may result in overheating. The back panel
also functions as an EMI shield.
Operator access is limited to the front panel of the 6180 Computer. This
includes the display, front panel, keys, and front panel doors (accessory
drive and mouse/keyboard connectors). Access to components behind
the rack or panel that the 6180 Computer is installed in is restricted to
authorized and properly trained personnel.
ATTENTION: Operator access is limited to the front
panel controls and access doors of the 6180 Computer.
Failure to observe this caution could result in severe
electrical shock and/or damage to the 6180 Computer.
Chapter Chapter Chapter Chapter
3
Chapter Objective
Operating Objectives
Operator Access