Rockwell Automation 6180 Industrial Computers - Manual (Page 128)

13–6 Keypad Configuration Utility Software
Publication 6180-6.0
The KCU Utility recognizes three file types.
File Type Description
.KEY Keypad configuration file
.BOO Boot firmware file. Cannot be edited. Supplied by
Allen-Bradley when upgrades of the boot code
firmware are required.
.APP Application firmware file. Cannot be edited.
Supplied by Allen-Bradley when upgrades of the
application firmware are required.
All file types can be downloaded to the Keyboard Interface Controller
(KIC) in the 6180 Industrial Computer.
To use the Keypad Configuration Utility, connect an IBM AT standard
keyboard and mouse with PS/2 connectors (if you do not have touch
screen or touch mouse) to the 6180 computer. If you are using the front
panel connectors, you must install jumper cables as shown below. These
jumpers route the keyboard and mouse ports from the processor board to
the front panel connectors. Make sure the correct ports are used.
File Types
Connecting the Keyboard
to the 6180 Computer