Rockwell Automation 6180 Industrial Computers - Manual (Page 95)

Adding and Removing Removable Media 7–5
Publication 6180-6.0
6. Remove the accessory drive / bracket assembly through the back of
the chassis.
7. Remove the screws that secure the accessory drive to the bracket.
This will vary depending upon the type of drive.
Installation
Note:
You can also use these procedures to install a front or rear
facing CD-ROM drive (without using the mounting
bracket). The lower bay floppy drive mounting bracket and
CD-ROM drive use the same sets of chassis mounting
holes.
To install a floppy using the lower bay mounting bracket:
1. Secure the floppy drive to the drive bracket using four screws
supplied with the bracket. Tighten screws to a torque of 6–8 in. lbs
(.7–.9 N•m).
2. Swing open the back of the computer chassis after removing the
three bezel latching screws.