Rockwell Automation 6180 Industrial Computers - Manual (Page 113)

Adding and R Adding and R Adding and R Adding and Removing Displays emoving Displays emoving Displays emoving Displays
and Backlights and Backlights and Backlights and Backlights
This chapter describes how to remove and install displays and
backlights.
The backlight uses Cold Cathode Fluorescent (CCF) tubes to illuminate
the display.
ATTENTION: Disconnect all power from the 6180
Computer before replacing the backlight. Failure to
disconnect power may result in electrical shock and/or
damage to the terminal.
ATTENTION: Do not touch any of the exposed
electronic components to prevent damage from
electrostatic discharge (ESD).
The procedures for replacing the plastic bezel/displays are the same.
If you are installing a bezel with no display, the procedures are the same
except for the number of electrical connectors to the bezel.
To remove a bezel/display
:
1. Disconnect the power from the 6180 Computer.
2. Disconnect all communication and power cables.
3. Remove the clips or mounting stud nuts that secure the computer to
the panel.
Important: There is metal tab that temporarily locks the bottom of the chassis
in the panel during mounting. This tab must be bent in before
bezel / chassis can be removed.
4. Remove the computer from the panel or enclosure.
Chapter Chapter Chapter Chapter
10
Chapter Objective
Installing and Removing
Displays and Backlights
Replacing the Display and
No Display Bezel