Rockwell Automation 6180 Industrial Computers - Manual (Page 114)

10–2 Adding and Removing Displays and Backlights
Publication 6180-6.0
5. Remove the three latching screws that secure the chassis to the front
bezel.
Figure 10- 1
6. Swinging the chassis open about 90 degrees.
7. Disconnect the electrical connectors from the front panel. Note the
location and orientation of the connectors.
Figure 10- 2
INSERT GRAPHIC HERE
8. Drive the hinge pin up using a slotted screwdriver (under the head of
the hinge pin) and a small hammer.
Figure 10- 3
INSERT GRAPHIC HERE
9. Remove the bezel/display from the chassis.